Hakko C1148 907 Replacement Medium Handpiece for 936, 937, 703, 928
Factory Refurbished 853-2 Preheater used to preheat a circuit board with large ground planes, heat shields, RF shields, etc., so the soldering iron can properly melt the solder 120vac 60Hz
Factory Refurbished 96E-V12 Analog Solder Pot includes dross removal tool and manual 120vac 60Hz
Refurbished 703 or 703B Digital Self-Contained Solder/Desolder Station with 2 each 907 50 Watt soldering handpieces and one 807 Desoldering handpiece with a new 60 Watt heater installed. 115VAC, 60 Hz three wire cord. operators manual.__NOTE: Handpiece stands may not be as depicted in the photo. Desoldering Handpiece holder may be mounted on the side of the station.__SPECIAL BONUS: 2 Desoldering tips of your choice FREE with purchase of any Hakko desoldering station ($34 value).
Refurbished 939-1 high performance digital soldering station, programmable temperature offset, temperature lockout feature, control card, 903 handpiece, stand, manual, ESD safe, 115vac, 60 Hz, 3 wire cord__SPECIAL - new spare A1245 2.4mm chisel tip included - Free
Refurbished FP101-01 or FP102-01 high output, temperature controlled soldering station utilizing composite tips with 70 watt heater and sensor built into the tip, 4 selectable heat ranges - 650, 700, 750, 800 degrees F, 120vac, 60 Hz. (used tip included).
SMD hot tweezer kit, 50 watt handpiece with stand and tip alignment tool for use with Hakko 926, 927, 928, 929, 936, 937, 939, 702, 703 stations. ESD safe, easily removes SMD chips and SOICs up to 25mm.
Analog variable temperature 936 power supply SMD hot tweezer station, 392-752 degree F range. 950 tweezer handpiece, 50 watt heater, ESD safe, easily removes SMD chips and SOICs up to 25mm, 120vac 60 Hz.SPECIAL - New 907 50 watt soldering handpiece and stand included, a $70 value! (while supply lasts).
Refurbished Hakko 936-12 Variable temperature, stackable power supply, 392-896 degrees F range, with new 50 watt 907 handpiece, new generic stand, ESD safe, 120vac, 60 Hz.
Refurbished Hakko 851-2 Analog SMD Hot Air Rework Station, includes 3 nozzles: 1.5mm ID, 2.0mm ID, 3.0mm ID, handpiece holder, nozzle holder, manual. Ideal for small chips with 2 terminations and transistors. 120vac 60Hz
Refurbished Hakko FX951-66 High Performance Variable Temperature Soldering Station, adjustable from 400 degrees F to 840 degrees F at plus or minus 15 degrees F, auto power shut-off after 30 minutes of non-use, programmable sleep temperature mode, temperature lock-out key, meets MIL-Spec, 120 VAC, 60 Hz. DOES NOT include tip.
Kester 1544 RA Liquid Flux used to augment Kester 44 RA flux cored in wire solder.
1 lb roll, High Temperature Alloy, 3.3% No-Clean Flux core
1 lb roll, 96/04,(4% Silver) Rosin Mildly Activated Flux core
Kester 959 No-Clean Liquid Flux used to augment Kester wire solder cored with 245 or 275 No-Clean Flux